solar pumping inverter
Active Inverter
CE
7500W
off-Grid Inverter
Single
Full-Bridge Type
Sine Wave Inverter
DC/AC Inverters
110VDC/220VDC
90V~139V
104V~131V
260V-180V
Less Than 5ms
220VAC
Pure Sine Wave
0.8
-20 Degree~+50 Degree
Available
50Hz/60Hz
Input and Output Voltage, Frequency, Output Curren
0.75 kVA
Less Than 3% (Linear Load)
Telecom and Industrial Power Applications
NASN
Carton
500*350*220mm
China
8504403090
Product Description
7.5kw Solar Pumping Inverter DC AC 220v MPPT Solar Inverter without Battery
A typical NASN solar powered pumping system consists of a solar panel array that powers an electric motor, which in turn powers a bore or surface pump by a solar pump inverter. The water is often pumped from the ground or stream into a storage tank that provides a gravity feed, so energy storage is not needed for these systems. PV powered pumping systems are a cost-effective alternative to agricultural wind turbines for remote area water supply.
A solar pumping system is available for almost all applications where an electric pump can be used. Because solar energy varies from one location to another, and over the course of a day, system design is important. Adequate water storage ensures that water is available whenever needed, and balances daily variations in water supply and demand. Thus a small pump only running when the sun shines, plus water storage, can often provide all that is requiremed for water supply.
Available power range in size from 750W to 150KW.
System constructure:
Solar photovoltaic pumping system consists of three components: solar panels, PV pump inverters and three-phase AC pump. Solar arrays have several in-parallel solar cell components, absorbing solar energy and convert it into electricity for the entire system power. PV pump inverter can control and adjust for the system. It can convert DC produced by solar panels into AC to drive the water pump. According to changes in sunlight intensity to adjust the output frequency, the pump inverter can get the maximum power point tracking, and make the max use of solar energy.
Features:
1. High efficiency>98%
2. With Soft start, VFD, MPPT
3. GPRS function (optional)
4. LCD display
5. Stainless steel, waterproof shell with IP65
6. Without battery and solar charge controller
7. Provide 2 years warranty
Applications:
Applied to 3 phase induction motor
§ residents living water.
§irrigation
§desert control
§animal husbandry
§water apply for sea island
§livestock watering
§water treatment projects
Datasheet:
More details:
More Details
Case
FAQ
Q1: What kind of EV Charger do you have?AC and DC charger with connectors Type2, CCS1/CCS2, CHAdeMO, GB/T, etc.
Q2: Do you provide customized product?
We provide OEM and ODM services for clients.
Q3: What is the delivery time of EV charger?
About 4-6 weeks.
Q4: What about your warranty of EV Charger?
Generally 2 years. Our warranty period depends on customer's requirements and we always put customer's need as priority.
Q5:How do you package it ?
A:We pack in cartons.
Q6:what's the MOQ?
A:For LOGO, color or other special requirements, a minimum of 20 is required. If you do not have these requirements you can buy
directly, we will ship within 3-10 days.
Q7:Can you produce according to the samples?
A:Yes, we can produce by your samples or technical drawings. We can build the molds and fixtures.
Q8:Do you test all your goods before delivery?
A:Yes, we have 100% test before delivery.
Q9:What is your terms of delivery?
A:EXW, FOB, CFR, CIF, DDU.
Q10:What is your terms of payment?
A:We accept all methods of payment: paypal, T/T, credit card, West Union... Please contact us for more details.
A typical NASN solar powered pumping system consists of a solar panel array that powers an electric motor, which in turn powers a bore or surface pump by a solar pump inverter. The water is often pumped from the ground or stream into a storage tank that provides a gravity feed, so energy storage is not needed for these systems. PV powered pumping systems are a cost-effective alternative to agricultural wind turbines for remote area water supply.
A solar pumping system is available for almost all applications where an electric pump can be used. Because solar energy varies from one location to another, and over the course of a day, system design is important. Adequate water storage ensures that water is available whenever needed, and balances daily variations in water supply and demand. Thus a small pump only running when the sun shines, plus water storage, can often provide all that is requiremed for water supply.
Available power range in size from 750W to 150KW.
System constructure:
Solar photovoltaic pumping system consists of three components: solar panels, PV pump inverters and three-phase AC pump. Solar arrays have several in-parallel solar cell components, absorbing solar energy and convert it into electricity for the entire system power. PV pump inverter can control and adjust for the system. It can convert DC produced by solar panels into AC to drive the water pump. According to changes in sunlight intensity to adjust the output frequency, the pump inverter can get the maximum power point tracking, and make the max use of solar energy.
Features:
1. High efficiency>98%
2. With Soft start, VFD, MPPT
3. GPRS function (optional)
4. LCD display
5. Stainless steel, waterproof shell with IP65
6. Without battery and solar charge controller
7. Provide 2 years warranty
Applications:
Applied to 3 phase induction motor
§ residents living water.
§irrigation
§desert control
§animal husbandry
§water apply for sea island
§livestock watering
§water treatment projects
Datasheet:
| Technical Specifications | |||||
| Model | HSPH7500H | ||||
| Solar Input | |||||
| Max Voc Voltage | 800V | ||||
| Min Vmp Voltage | 400V | ||||
| Recommend Vmp Voltage | 500Vmp<DC Input<750Voc (Only Solar Input) 540Vmp<DC Input<700Voc (Hybrid Power Input) | ||||
| Max MPPT Efficiency | 99% | ||||
| Max Input Current | 26A | ||||
| Number Of Strings | 1 | ||||
| Note | Automatic MPPT Function to Identify the Voc and Vmp of Solar Panel, no need programming | ||||
| AC Input | |||||
| Voltage | 3 Phase 380/400/440V | ||||
| Rated Input Current | 17.3A | ||||
| Hybrid Mode | AC supplement automatic when solar low power and AC disconnect automatic while solar power recovery | ||||
| AC Output For Pump( AC Induction Motor) | |||||
| Max Adapted AC Pump Horse Power | 10HP | ||||
| Max Adapted AC Pump Power | 7500W | ||||
| Drive Mode | Variable Frequency Drive 3Phase | ||||
| Max Output voltage | 380/400/440V | ||||
| Max Output frequency | 50 ~ 60 Hz (support program range 15 to 60Hz) | ||||
| Rated Output Current | 17A | ||||
| Other Characters | |||||
| Max Efficiency | 97% | ||||
| Water level Sensor(well / tank) | Yes | ||||
| 4G/Wifi Monitor&Controller | Optional | ||||
| Display | LCD display | ||||
| Waterproof | IP65 | ||||
| Noise | < 50dB | ||||
| Cooling Method | Force Cooling by Fan (IP68) | ||||
| Protection | Solar DC input Low/Over Voltage Solar DC Input Reverse Polarity AC Output Short-circuit AC Output Over Current Over Temperature Over Load Over Flow of Tank Against Lightning AC Input / Output Phase Lost Dry-Run (detecting by Sensor or Software) | ||||
| Operating Enviornment | |||||
| Operating environment temperature | -10 to 60ºC , Above 60ºC need to derate load | ||||
| Max Humidity | 95%RH | ||||
| Using altitude | < 3000m , Above 3000m need to derate load | ||||
| Others | Prohibiting the installation location: direct sunlight, thick dust, corrosive gas or oil mist, flammable gas, liquid.etc | ||||
| Package | |||||
| Size( L*W *H) | 500*350*220mm | ||||
| Weight | 9.5KG | ||||
More details:
More Details
Case
FAQ
Q1: What kind of EV Charger do you have?AC and DC charger with connectors Type2, CCS1/CCS2, CHAdeMO, GB/T, etc.
Q2: Do you provide customized product?
We provide OEM and ODM services for clients.
Q3: What is the delivery time of EV charger?
About 4-6 weeks.
Q4: What about your warranty of EV Charger?
Generally 2 years. Our warranty period depends on customer's requirements and we always put customer's need as priority.
Q5:How do you package it ?
A:We pack in cartons.
Q6:what's the MOQ?
A:For LOGO, color or other special requirements, a minimum of 20 is required. If you do not have these requirements you can buy
directly, we will ship within 3-10 days.
Q7:Can you produce according to the samples?
A:Yes, we can produce by your samples or technical drawings. We can build the molds and fixtures.
Q8:Do you test all your goods before delivery?
A:Yes, we have 100% test before delivery.
Q9:What is your terms of delivery?
A:EXW, FOB, CFR, CIF, DDU.
Q10:What is your terms of payment?
A:We accept all methods of payment: paypal, T/T, credit card, West Union... Please contact us for more details.
