Hook Twin Tie Plates Arema Plan 241 Used in North America, Hook Twin Tie Plates, Railroad Nails

Hook twin tie plates are used for frogs, guard rails and behind the heel of switches. They are produced to AREMA standard design and widely used throughout North America for standard rail sections. Hook twin tie plate is very versatile for fitting most rail sections. Part of its versatility comes from the pre-drilled slotted holes, which allow it to fit almost any rail section. Hook twin tie plates are used in pairs, side by side on the same tie to adapt to different tie spacings, frog angles, etc. The standard AREMA thickness is 3/4", but a 5/8" thickness is common for industrial rail track work. And these two typical applications are shown as below:

Hook twin tie plates are manufactured per AREMA plan 241. Hook twin tie plates generally has 3 types of hooks: Type L (Low), Type LR (Low Reverse) and Type H (High). Type H tie plates do not have the slotted holes but have a higher hook designed to fit over the base of a manganese frog. If the hook of a hook twin tie plate interferes with a joint bar, then the hook can be cut off or bent to a vertical position.

AGICO supplies hook twin tie plates up to AREMA plan 241 standard.

AREMA 3/4'' thick Hook Twin Tie Plates

AREMA 1'' thick Hook Twin Tie Plates

If your rail operation needs to replace or add new hook twin tie plates, please feel free to contact us now. Our rail fasteners experts will help you choose the right type of hook twin tie plates that are best suited to your needs. You can count on us!