Vehicle Tracker Support Overspeed Alert (MT08A), Vehicle Tracker, GPS Tracker

1. Main functions:


For motorbike/Truck/Fleet managment
Wide input voltage range: 30-100VDC
GSM quad band, SMS/GPRS(TCP/IP)
GPS chipset with high sensitivity
Intelligent activation of GPS positioning
High integrated, mini size, easy to install
Built-in high sensitive GPS&GSM antennas.
Built-in battery
Sos emergency alert
Vibration alert
Geo-fence alert
Parameters checking
Overspeed alert
External power supply cut off alert
Get location via google map link
Get real address by sms directly
Track by GPRS interval report


Introduction:

1. Security Function: If the ACC wire is connected to the ACC switch, this equipment will start the security function automatically in five minutes after the vehicle engine is turned off. If vehicle vibration occurs within one minute, the equipment will enter the security status with 1 minute delay, and will enter the security status unless no vehicle vibration occurs.

2. Phone Mode:
After the car owner dials the equipment, it will disable defence. The device can set 3 control number. Password needed when change the number, if forget the password, the operator can use the "factory reset" function.

3. Sleep Mode:
After entering the security status, if no vehicle vibration occurs within 20 minutes, this equipment enters the sleep mode. In the sleep mode, this equipment neither locates nor uploads data, but can send/receive messages and make/answer calls, so as to achieve maximum energy saving.

4. Wire Cutting Alarm:
Under the security status, when the power line is cut off, the equipment will alarm the car owner and start the back-up battery which can work 7 to 10 hours

5. Vibration Alarm:
Under the securiy status(including the sleep status), if vehicle vibration occuus, this equipment immediately disconnects the relay and dials the mobile phone NO of the Vehicle owner to give an alarm, meanwhile, it wakes up the GPS position and uploads the alarm and location date to the service platform.

6. Motion Alarm
After the vehicle engine is turned off and not enter the security status, if the vehicle has been detected to be moved over 200 meters, this equipment will dial the vehicle owner' mobile number and send the location SMS.


7. SMS Tracking
Anytime send a SMS to check the vehicle, the equipment will reply a location tracking SMS. Under sleep status, the equipment will reply the final location before the device under sleep.

8. Geo-fence
Entering the platform to set up the drive route. If the vehicle is out of fence, the equipment will send an alarm SMS.

9. Real-time Tracking
Entering the platform, check the vehicle's status, route and speed.

10. Low voltage Alarm
V If the back-up battery use to low voltage, the equipment will send a SMS to alarm the car owner

12. Prevent Rob
The car owner sends a SMS command to cut off the device,